11

Fucking Chinese designers...
Spent all afternoon leveling the 3D printer table while scratching it a lot.
all afternoon to understand that one piece is bent and the extruder is a lot lower it should have been...
Meanwhile, leveled the table with my knowledge of CNC and a specific tool that allows me to take measures up to 0.01mm...

Could have saved €20 on this fucking auto leveler that doesn't really work.

Comments
  • 0
    Fk this, Just took it out, after hours of frustration and scratching, damaging the machine.
  • 0
    Fuck this...
    stopped watching tutorials.
    Used my own knowledge on CNCs to level up everything and place the switches with a 0.2 precision by hand.
    30 minutes to do it by hand.
    I just hope I didn't fuck fucked the machine with so many collisions.
  • 0
    Man... I'm building a fucking 3D printer... so many loose parts, others too tight... I do NOT recommend Anet A8 for noobs.
    finally printing my first piece (second attempt, first the extruder was still too low, now it seems to be too high...)
  • 1
    FINALLY!!!!!!!
    So... 5 or 6 attempts later, lots of calibrations and it's finally good!!
  • 1
    This post was a struggle, beginning to end. +1 for perseverance
  • 1
    Well... struggling since Monday...
    SO FRUSTRATED!!!!
    So many mistakes... had to lose the printer instead of tightening it because It would get stuck...
    Basically took me one day to mount, 3 days to debug and correct.
    One thing I can say, It's can handle a few hits and lots of power turn off in middle of impression lol

    Wasted 20€ ... ended up using a pachometer and the tool in the image to calibrate up to 0.05mm :D
  • 1
    But the tool goes to 0.01mm...
    5 thousands is terrible. You can do better 😀
  • 0
    @Gregozor2121 Yes, but it takes like two hours to level to 0,01 while the printer doesn't need to be that precise, especially when I'm still fixing, changing and upgrading.
Add Comment