Gotta say, pretty good from a printer i forgot to level

The parts seem usable. What printer were you using? I have some bed leveling issues with ‘mine’ where I can’t use the full bed size.

@lastNick anycubic kossel something something pulley

The slicer and firmware settings seem a bit off, maybe play with these

Starts with "hey, it's usable even without leveling".

Continues after incredible amount of hours with "maybe if i'll adjust the front by 0.001mm and right by -0.002mm i'll fix this 2cm slightly uneven glitch in fill pattern".

Ends with "reset to default" and being happy with basic level adjust as long as the fill creates continuous surfaces.

...oh, wait! theres ton of other calibration exercises you haven't gave up yet

@qwwerty nah, im slowly making it better, these were just washers for some broken stuff at home, so they work fine

@iKameo for some reason the diameter was 2.75 lol

@Haxk20 My endstops are fine Automatic bed leveling shows +.2 mm at left front corner and -.1 at right front corner but I only have one adjustable screw in the middle. The back side is fine though